To make a long story short, we bought an ’82 GMC C20 3/4-ton diesel truck … with a shortbed and a 350ci small-block. Someone had swapped in a gas engine, cut the frame, added a shortbed, and done a clean job of the conversions to boot. For $900 we purchased a cool 2WD truck with no emissions testing requirements and an engine that “needed work.”
We were told by the third-party seller that the owner had run it low on coolant and blown the head gaskets. Upon getting it home, transferring the title from two owners prior, adding a battery and little fuel, we were able to get the truck running and confirmed blown head gaskets without any leakdown test.
With only $900 into this unique 3/4-ton shortbed, bad engine heads were no big deal. Right from the get-go, we planned on building a 350ci V-8 in some boxy Chevy truck. Purchasing the exact truck we did was just a lucky find, as we really were looking for the right motor and price more than a unique truck to start with.
Dreams of small-block building came after rifling through a Summit Racing catalog and finding that we could make more than 350 horsepower out of a 350ci V-8 for less than we’ll eventually spend on tires for this truck. Summit has a number of top-end kits for both small-block Chevys and small-block Fords that come with loaded aluminum heads, a cam, an aluminum intake manifold, a timing chain set, and the necessary gaskets.
We called the hotline and went about ordering the kit when our Summit phone sales rep intervened and suggested a different kit that was actually a little less expensive and had a better powerband for what we wanted. For about $1,300, we got the SME-K-355-400 Top End Kit coming to the office that makes power from 1,500 to 5,000 rpms. If we could build a 350-plus-horsepower truck for less than $2,500 (including the truck), we would be winning.
02. The Summit Racing Street & Strip Top End Kits come with a pair of assembled aluminum
We waited to tear down the original engine in the truck because it could still move itself around the yard, even with a blown head gasket. When the parts arrived from Summit a few days later, we pulled the truck into the garage and started in.
A couple hours later, we had the engine torn down enough to find evidence of more than just head warpage and blown gaskets. Unfortunately, there was some scarring and even a little pitting on the cylinder walls. Our rare find had just gotten more expensive than we wanted, but not so much so that we’d scrap the project and use the Top End kit for something else. Instead, it was time to scour Craigslist to see if we could find a nice replacement short-block for our budget Mighty Mouse motor. Rebuilding this block would take more time than we wanted, and we’re going to see if we can find a loaded short-block that’s already been rebuilt and someone doesn’t want anymore.
We’ll find a block, have this Summit Top End kit installed, and get this unique truck running soon enough!
03. The Summit aluminum heads (SUM-162109) included in the kit come assembled with valves and springs in place. All you’ll need to add are your original or new rocker arms and pushrods once the heads are bolted in place. They have a 170cc intake runner volume, 69cc exhaust runner volume, 62cc combustion chambers, standard-location rectangular intake ports, and D-shaped exhaust ports. It’s worth noting that these aluminum heads have a CARB E.O. number and are street-legal on ’95-and-older vehicles. If you were to buy these heads alone, you could put them on a pre-’95 Chevy V-8 and still be smog legal.
04. The included hydraulic flat tappet camshaft (SUM-1103) comes with hydraulic lifters
05. A dual-plane aluminum intake manifold (SUM-226012) is also provided in the package. I
06. If renewing the entire top end of an engine, it makes sense to replace the timing gea