Need a winch for your truck but don’t have $1,000-plus to spend on one? Well, Harbor Freight has got your back. For less than you might spend on a single tire for your big ride, you could have yourself a Badlands winch. And, no this isn’t some special that’s only available for a week after you read this; that’s just Harbor Freight’s price on their new line of Badlands winches. We’ve haven’t put too many pulls on ours yet, but we’ve definitely gotten it into action a few times, with positive results. The line speed isn’t slow, and the quality and appearance of the winch seems top notch. We’ve tried some “lesser expensive” winches before, and we can tell you firsthand that this winch is in a league of its own. It competes with the high-end winches in performance, and the economically-priced winches in cost. The Badland’s solenoid box mounts directly to the top of the cross bars over the winch spool. It’s a nice way of mounting the box on top of a clean-looking winch housing. It’s almost unbelievable that you could get this nice of a 12,000-pound winch for just $399.The Badland’s solenoid box mounts directly to the top of the cross bars over the winch spo While it’s a clean setup, the solenoid box can present a fitment problem if your winch bumper doesn’t leave enough room to get the box on (top of the winch). It wasn’t compatible with our original recipient bumper, but we had no problem fitting it onto our Super Duty’s winch bumper. The winch uses a standard 10.0 x 4.5-inch mounting pattern and has 3.5-gauge power cables.While it’s a clean setup, the solenoid box can present a fitment problem if your winch bum The pendant-style controller at the end of a 12-foot wire allows you to stand away from the winch as you reel the 100-foot cable back in. The included roller fairlead comes with nylon bushings to keep the rollers rolling smoothly.The pendant-style controller at the end of a 12-foot wire allows you to stand away from th Badland Winch Specs Model: Badlands 12,000-pound winch Motor: 6hp series-wound motor (12VDC) Duty cycle rating: 5 percent (45 sec @ max-rated load) Geartrain/Ratio: Three-stage planetary/265:1 Brake: Auto load-holding 8.8 x 2.5-inch drum Cable: 0.375-inch diameter, 100 feet Cable nominal strength: 14,400 pounds Dimensions: 20.9 x 6.4 x 8.3 in Mounting Pattern: 10.0 x 4.5 in Weight: 86.8 pounds (complete with steel cable) Line Performance (First Layer of Cable) Line Pull (lbs) Line Speed (fpm) Amp Draw 0 16.4 72 2,000 14 115 4,000 9.9 159 6,000 9.1 198 8,000 7.6 242 10,000 6.1 281 12,000 5.0 320 Sources Harbor Freight 3491 Mission Oaks Blvd Camarillo CA 93011 800-444-3353 www.harborfreight.com By CC Rogers Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues! More from off-roadweb: Bypass Reservoir Shock Rebuild by Fox Factory - Shock Rebuilding Off-Road Winch Guide - Which Winch For You? Small-Block 350 Engine Build - Mighty Mouse Motor: Part 2 Toyo Open Country A/T II Tire Review - Tech Inspection Sponsored - Links *Please enter your username *Please enter your password *Please enter your comments Comments: Not Registered?Signup Here Comments (1024 character limit) HomeForumsRSS FeedsLicensing FeaturesBlogsSite MapUser Submitted Content TechVideoContact UsTerms of Use Off Road AdventuresWallpaperSubscribePrivacy Policy DepartmentsThis MonthSubscriber ServicesAd Choices Past IssuesReprintsGive a Gift MailContributors © 2013 Off-Road, Source Interlink Media All rights reserved. LIWWBIIS8