Do you remember the cover of the August '05 Off-Road? That issue, Gary Hough's previous prerunner graced the cover in a great airborne shot by Randall Jachmann. Fast-forward to September 2006 and witness Gary's newest desert dominator built by Dirt-Tech of Escondido, California. This time around, Gary wanted something a little more unique -- a truck built just the way he wanted it and in a short amount of time, as he did not want to miss the '06 desert season. This truck was built in less than three months' time. No, we didn't say three years -- three months. With this truck now being Gary's second incredible vehicle, we can only wonder what his third will be like.
The first thing we noticed when walking around this beauty were the side mirrors, real headlamps, license plate, rear brake lights and turn signals. This truck even has a real vehicle identification number (VIN) from the original Ford F-150 that it once was. From front to back, the main chassis is built using 1.75-inch, 4130 chrome-moly tubing -- nothing but the best from Dirt-Tech. Trailer Products produced a great set of rear fiberglass fenders and a custom-made one-piece front clip including louvers, a billet grille, and headlamp openings. A fresh coat of vibrant red paint was blasted over the body by E&R Paint in Vista, California, really making the truck stand out. On top of the cab, we recognized five Baja Designs SolteK off-road HID lights installed on a lightbar that is completely removable and remotely controlled in the cab using a linear actuator.
As we made our way under the hood, we found a Chevrolet small-block 418ci engine built to produce 620 rear-wheel horsepower and 580 lb-ft of torque by Dan Martin Engines. Keeping all those ponies cool is a Ron Davis radiator, a wet-sump oiling system, and a set of Spal fans. Richards Performance Muffler of San Diego, California, built Gary a set of 8-into-1 collector headers that sound like a rocket ship blasting off when Gary pushes his foot to the floor. Giving the engine life are a Chevrolet alternator, a Tilton starter, and a complete 8.8 MSD ignition system, spark plug wiring, and distributor. In order to get all that power to the rear, Gary called on an expert transmission builder in Steve Culhane. Steve built a Turbo 400 transmission for this truck using a TCS torque converter, dual Fluidyne transmission coolers to keep it cool, and a Winters race shifter to throw the gears. The front chrome bumper was also completed by Dirt-Tech as well as the aluminum name plaque that doubles as chassis support.
Climbing underneath and diving into the rearend, we found a Chrisman rear axle custom-built for Gary's truck using a full spool to keep both tires turning at the same time, all the time. Inside the housing is a set of 40-spline Chrisman axleshafts with a gear ratio of 600. Carrying power to the rearend is a custom driveshaft provided by Oceanside Driveline of Oceanside, California. While laying in the dirt, we discovered a 60-gallon Fuel Safe fuel cell located just behind to the rear which should allow more than enough run time between stops. A full lineup of custom Dirt-Tech skidplates was installed to keep the terrain from doing damage. They are made from 1/4-inch 6061 aluminum.
We now understand what's pushing the truck, but what stops it? CNC six-piston 14-inch front and rear disc brakes have been installed using a CNC master cylinder and Crown Industries brake lines. Gary chose a Howe Performance steering box and hydraulic assist to turn this beast with a custom steering column built by Dirt-Tech out of 3/4-inch 4130 chrome-moly tubing. Dirt-Tech also created a custom-length tie rod to help make sure the 37-inch BFGoodrich Project T/A tires running on Robby Gordon 17x8 beadlock wheels are in control.