The '89 Toyota truck spread across these pages rolled off the assembly line some 16 years ago. It lived a very gentle existence for the first half of its life as commuter and weekend-trip transportation. In 1996, the present owner, Mike Lewis, purchased the lightly used rig and began using it as his daily driver. An added camper was removed from the bed and Mike used the truck for some light-action wheeling running 31-inch tires in the desert near Phoenix.
For a number of years, the truck stayed mostly stock as Mike explored back roads and trails. The IFS served him well with a comfortable street and off-highway ride, getting him through most of what he demanded of it.
A few significant events happened and things started to change. On one trail outing, Mike bent the rear driveshaft on a boulder and was forced to drive the truck some considerable distance with it bent and vibrating badly. He was stuck for nearly a week commuting to work and back with this malady, and that's when something went awry. While driving down the highway, the tranny could take no more of the shaking and split its entire aluminum case in half. At this point, it was clear to Mike that he was going to need more clearance if he wanted to play in the rocks.
Other subsequent events also pushed the truck toward a makeover. As it would happen, twice within a period of several months the Toyota fell off a service lift in a repair garage, damaging the bed each time. It seemed that if the rocks weren't going to chew at the bed, something else would. The transformation began as the crinkled bed was removed to make way for a custom-designed and -fabricated tube bed. Mike's friend, Larry Zager, bent and crafted a good-looking and functional rear bed from 1-3/4-inch round tubing. This area still serves to haul cargo and camping gear but is much less vulnerable to rock rash than the sheetmetal was. The bed is painted to match the factory Metallic Red of the cab and sports aluminum diamond-plate panels. Rear lighting is provided by a big rig taillight panel that was modified as needed, and removable mudflaps help keep the truck legal on the road.
Further tube work was crafted inside and up front. Larry fabricated a front bumper that protects the front end and increases approach angle and clearance. Toyota cabs are well designed and strong, but Mike wanted added safety assurance in the event rubber should point skyward. A full inside cage was added. Tubing passes around and across the top inside of the cab and has been skillfully run forward through the dash area down to the floor.